Harvey Hv3 Water Softener Installation Manual Free __exclusive__ -

Attach a flexible hose from the Outlet Port of the Harvey HV3 to the plumbing network’s Outlet Valve .

Run a manual regeneration cycle to ensure everything is functioning correctly. Maintenance and Troubleshooting

Locate the overflow connection on the lower side of the salt cabinet. Connect a dedicated flexible tube to this outlet and route it downward through an external wall to the outside of the property.

Run a nearby tap for a few minutes to clear any air or fine resin particles from the system. UK Water Softeners Digital Setup (If Applicable) BLOCK SALT SOFTENER INSTALLATION INSTRUCTIONS harvey hv3 water softener installation manual free

The most reliable free method: email Harvey customer support directly. Ask for a digital copy of the HV3 manual. They almost always send a PDF free of charge to registered owners.

– Go to harvey.co.uk/support and request the HV3 manual via their contact form. They usually email a PDF within 24 hours.

Firm, level ground close to the mains stopcock and a suitable waste water drain. Attach a flexible hose from the Outlet Port

Insert two blocks of Harvey salt into the front compartment. 7. Testing the Water

[ Mains In ] ---> ---> ( Inlet Valve: OPEN ) ---> [ Softener IN ] | ( Bypass Valve: CLOSED ) | [ Home Feed ] <--- <--- ( Outlet Valve: OPEN ) <--- [ Softener OUT ]

Connect the to the waste outlet and run it to a drain with a minimum 20mm air gap to prevent back-siphoning. Connect a dedicated flexible tube to this outlet

1 x Three-valve bypass manifold (Inlet, Outlet, and Bypass valves) 2 x Stainless steel braided high-flow flexible hoses 1 x 3/8" High-pressure plastic drain line tube 1 x 1/2" Overflow line tube 1 x WRAS-compliant air gap fitting 1 x Check valve (non-return valve) WATER SOFTENER INSTALLATION GUIDE

Before starting any installation, it is crucial to prepare the installation site and gather all the necessary information and tools.