Approximately 20 to 80 seconds (built-in hysteresis to prevent flickering caused by car headlights or sudden clouds)

Connect phase and neutral to the designated input terminals.

The IC 2000P will only trigger the ON command if the lux level is below the threshold. 5. Troubleshooting Possible Cause Incorrect wiring, sensor blocked, or lux set too low. Check wiring, clean sensor, or increase lux setpoint. Lights stay on at day Sensor in shadows, lux set too high. Relocate sensor, decrease lux setpoint. Screen is blank No power supply. Check circuit breaker and connections. "Error" on screen Programming conflict. Reset device and reprogram. 6. Conclusion

Summary

The Lux threshold may be set too low (e.g., 2 Lux). Turn the dial up toward 100 Lux to see if the relay engages.

The photocell cable can be up to 100 meters long, but it should not be run parallel to high-voltage mains power conductors to avoid signal noise. Programming Guide

| Parameter | Value | |-----------|-------| | Brand | Merlin Gerin / Schneider Electric | | Series | Multi 9 | | Model | IC2000 P | | Number of Poles | 1 NO (Normally Open) or 1 CO (Changeover) – verify on relay label | | Coil Voltage (Typical) | 24 V DC, 48 V DC, 110 V AC, 230 V AC (check your unit’s marking) | | Contact Rating | 6 A / 250 V AC (resistive) | | Mounting | DIN rail (35 mm) | | Termination | Screw terminals (plug-in base) | | Status Indicator | Mechanical flag & LED (depending on version) | | Protection Class | IP20 |

The Merlin Gerin Multi 9 IC 2000 P is a part of the Multi 9 range of protection devices, designed to offer a wide range of protection functions for electrical circuits. This device is particularly notable for its modular design, making it highly adaptable to various applications and easily expandable as per system requirements. The IC 2000 P model is equipped with advanced features for circuit protection, including overcurrent, short circuit, and earth leakage protection, among others.

Upon first power-up or after a reset, you must complete the following initial setup: Select your preferred language (e.g., English). Date/Time: Set the current year, month, day, and time.

Install it at a height where it can be cleaned occasionally, away from heavy foliage or structural shadows. Wiring Diagram and Electrical Connections

Feedback