To prevent overloading the Arduino, remove the jumper next to the terminal block.
A: No. It is a clone of Adafruit Motor Shield V1 and is only compatible with the Adafruit Motor Shield V1 Library .
The L293D driver can get hot; ensure you are not exceeding 0.6A0.6 cap A per channel. hw 130 motor control shield for arduino datasheet better
Remove the PWR jumper if you are using an external power source above
This is where most users get confused. The HW-130 has specific jumpers that change how the board operates. To prevent overloading the Arduino, remove the jumper
Built-in thermal shutdown and internal kickback protection diodes. 2. Pin Layout & Functions
The HW-130 has no official datasheet – it’s a clone of a clone. But now you know its soul: an L298N chip, a handful of diodes, screw terminals, and a heroic ability to get your robot moving. Treat it with respect for heat and power, and it will serve faithfully. The L293D driver can get hot; ensure you are not exceeding 0
Here's a step-by-step guide to get a simple motor spinning:
4 DC motor channels (M1, M2, M3, M4) OR 2 Stepper motors.
A: This is almost always a power issue. First, ensure you are using an external power supply for the motors via EXT_PWR . Second, verify that the 5V-EN jumper has been removed. Finally, check that all ground (GND) connections are common between the Arduino, the shield, and the external supply.