Xmtd-2201 Manual Jun 2026

: Typically, terminals 1 and 2 are for the 220V power supply, while other pins are designated for the sensor input and relay output. Refer to the XMT series diagram for specific terminal labels.

The XMTD-2201 balances reliable hardware with high mechanical vibration resistance, protecting it from the rigorous conditions of factory floors. Specification Parameter Detail Value / Range 72 × 72 × 72 mm (Cutout: 68 × 68 mm) Power Supply AC 220V ±10%, 50/60Hz Power Consumption ≤ 3 Watts Measurement Accuracy ≤ 1.0% Full Scale (FS) ±1 Bit Sampling Rate 3 times per second Supported Sensors Thermocouple (K, E) or RTD (Pt100, Cu50) Control Modes Two-position ON/OFF or Time Proportional Primary Output Types

Press the or ▼ keys to shift the numerical values up or down until your precise process temperature target is visible on the screen.

Illuminates when the control output (heating/cooling element) is active. xmtd-2201 manual

Allow it to cycle several times at this lower setting before moving to your final desired temperature. This "self-tuning" period prevents the heating element from running wild on the first try.

Here is a deep dive into what makes this "brain" tick and how to actually get it running. 1. The Specs: What’s Under the Hood?

Triggers alarm relay if PV rises above this value. 50.0 Full scale limits LCK : Typically, terminals 1 and 2 are for

The feedback loop is simple: Green means it's actively heating, and Red means it has stopped. 3. Wiring Tips (To Avoid the "Magic Smoke")

The XMTD-2201 is designed for reliability and high accuracy in demanding industrial environments. 85–264V AC, 50/60 Hz Power Consumption: Less than 5W Measurement Accuracy: ±0.5% of full scale (FS) ± 1 digit Sampling Cycle: 0.5 seconds

Allow the controller to warm up for 30 minutes to ensure accurate temperature sensing. Specification Parameter Detail Value / Range 72 ×

To mount the instrument securely onto a system command panel, follow these steps:

If the heat goes way past your SV before settling, you may need to adjust the Hysteresis (P) Differential settings in the internal menu.

Use the arrow keys to specify your threshold. For instance, setting an SV of 200°C with an OH value of 2°C means your heating element will reactivate when the room drops down to 198°C, preventing excessive cycling. Save by pressing . Wiring Layout and Terminal Connections