The most common cause. The heater element inside the hot air gun has burned out or its wire is broken.
Does the error pop up or after a few seconds of heating?
Unplug the unit, unscrew the hot air handle casing, and look for loose soldering points on the heater element terminals. 2. Testing the Heating Element
If the element is faulty, you can purchase a "Gordak 952 Heating Core" online quite cheaply. the old wires, noting their positions. Slide out the old ceramic core. gordak 952 he error portable
Always ensure the unit is unplugged and fully cooled.
The heating element is the most common point of failure. You will need a to perform these continuity tests.
Remove the screws holding the plastic casing of the hot air gun. The most common cause
If your local power grid flickers, use a surge protector or voltage stabilizer. Conclusion
The internal heating element in the gun has failed or broken.
If your tests confirm a failed component, here’s how to replace them on a Gordak 952: Unplug the unit, unscrew the hot air handle
With patience and a multimeter, you can solve the "HE" error and restore your Gordak 952 to full working order, saving both time and money.
If you are currently troubleshooting a specific machine, let me know:
| Function | Specification | Details | | :--- | :--- | :--- | | | Model | GORDAK 952 / 952 HE | | | Rated Voltage | 230 V AC, 50/60 Hz | | | Total Power | 270 W | | | Portability | Built-in carry strap | | Hot Air Rework | Temperature Range | 150℃ – 500℃ | | | Pump Power | 45 W (Membrane Pump) | | | Airflow | 0.16 – 1.2 Nm³/h (Stepless Adjustment) | | | Noise Level | < 45 dB | | Soldering Iron | Temperature Range | 200℃ – 480℃ | | | Power | 60 W | | | Output Voltage | 24 V AC | | | Heater Type | Ceramic | | Safety | Ground Potential | < 2 mV | | | Ground Resistance | < 200 mΩ |
If you transport your Gordak 952 to remote work sites, remember that these units feature safety shipping screws on the bottom panel. Always remove them before turning the machine on to avoid heavy mechanical strain, and reinstall them during transit to protect the pump components.