|
| |
Copyright © 2025, Michael D. Jenkins, Esq. and Ronin Software
All Rights Reserved
WALL STREET RAIDER v. 9.75 INFORMATION AND DOWNLOADS
An "...IMAGINATIVE, STIMULATING, EDUCATIONAL..."
Business Simulation -- Investor's Business Daily
|
Always replace the thermal paste or thermal pads beneath the RF power amplifier module (U101) when reattaching the PCB to the chassis. Failure to do so will cause immediate thermal runaway and destroy the transmitter module.
Inject a calibrated -110 dBm signal at the operating frequency. If no signal appears at the 44.85 MHz first IF test point, replace the first mixer FET or check the LO injection level. Fault 3: Low or No Transmit Power
If the radio was connected to a reversed power source, this diode shorts out to protect the internal circuitry. Use a multimeter to check if it is shorted to ground, and replace it if necessary. Symptom: Poor Receiver Sensitivity
Used primarily for programming, tuning, and standard voice accessories. 8V DC (Max 100mA) Pin 2: BLINK (LED Control) Pin 3: Hook Switch (Monitor) Pin 4: Ground Pin 5: Mic Audio Input Pin 6: PTT (Push-To-Talk) Pin 7: SCI / BUS+ (Programming Data Line) Pin 8: Handset Audio Output 3. Comprehensive Alignment and Tuning Procedure
Experienced bench technicians frequently run into a few common issues with the GM3688. Symptom: No Power
Do not probe your GM3688 with a multimeter blind. You will short the 8-volt rail and kill the controller board. Do not guess which capacitor replaces C262 (I have the manual—it is a 10uF 16V Tantalum).
The 16-pin accessory port supports a wide range of expansion options for custom installations.
Maximizes receiver sensitivity across the entire frequency split.
Over years of service, internal crystal oscillators can drift, causing the radio to stray off-frequency. To correct this, you must perform a radio alignment. Required Equipment A calibrated Service Monitor or RF Signal Generator. A digital multimeter (DMM). An inline wattmeter and dummy load (50 ohms).
Connect the radio's antenna port to the RF communications analyzer via an inline dummy load. Power on the radio and launch the . Select Tuning -> Transmitter -> Reference Oscillator . |
DOWNLOAD FREE TRIAL VERSION OR PLACE ORDER:
We believe in "try-before-you-buy," so to download a
free copy of the "shareware" (evaluation) version of Wall Street Raider (for
Windows XP/Vista/7/8/10), click here.
Or go to our Downloads page
to download a shareware copy of Wall Street Raider from any of
dozens of major shareware download sites.
To order the registered version of Wall Street Raider
or Speculator or our other products, go to our secure
https://www.WallStreetRaider.com
site for ordering instructions.
UPDATES/UPGRADES AND SUPPORT:
See the updates page to see what improvements have
been added since the version you currently have, so you can decide if or when to
purchase upgrades/updates. To contact Ronin Software for CUSTOMER SUPPORT,
click here
|
REVIEWS AND USER COMMENTS:
Take a look at our comments page, to see what
users say about Wall Street Raider.
motorola gm3688 service manual exclusive Or, view a series of YouTube
STRATEGY VIDEOS one game reviewer created, showing
you what playing a game of Wall Street Raider is like, plus his commentary. These
are the first of a series of videos this chap (an obvious W$R junkie and expert)
is creating, all of which are accessible on YouTube. The videos will give you an
idea of some of the things you can do in Wall Street Raider (based on Version
7.60 and, in a new series, on Versions 7.8x, with 8.0 to come) and strategies for
generating trillions (or more) in profits, trading stocks, options, futures and
dealing in interest rate swaps. He has also begun posting a series of
TUTORIAL VIDEOS on
YouTube,
including a NEW (2021) TUTORIAL on
VERSION 9.0 of Wall Street Raider.
Wall Street Raider has been published and under continuous development
since 1986, and it has received a number of very favorable reviews
over the years from major Web sites, such as ZDNET, Download.com and PCWorld,
as well as highly favorable reviews in print publications, including the Wall
Street Journal, Byte Magazine, PC World, and, on June 22, 2000, we rated a
two-column, very favorable front-page article in Investor's Business Daily,
which called W$R an "...imaginative, stimulating..." business simulation.
(That was a review of the old DOS version -- we came out with the much more
sophisticated Windows version a year later.)
Previously, respected computer columnist Jerry Pournelle had written of W$R,
that "You can really learn something about stocks, mergers, takeovers
and the general world of finance, and have a whacking good time in
the bargain."
Always replace the thermal paste or thermal pads Or read this detailed review of W$R on the
Daily Speculations web
site of legendary hedge fund manager Victor Niederhoffer,
with the review written by Sushil Kedia, a frequent guest on CNBC in India. (In one
of his books, George Soros wrote that Niederhoffer was
the only one of his managers who ever retired voluntarily from trading for him while
still ahead.) Niederhoffer's hedge fund was ranked #1 in the world, earning 35% a year
from inception to 1996 but, alas, he was nearly wiped out in 1997 by excessive
speculations in Thailand. Since then, he says he has been "...crawling back up the stairs,
not entirely without success," after mortgaging his house and selling off his collection
of antiques in 1998. As in Wall Street Raider, the real financial world is a jungle, in
which one can go from riches to rags in a heartbeat....
SAMPLE SCREEN SHOTS
Click here to see a sample screen shot of Wall Street Raider (Windows version).
Or here, to view a sample Entity Research Menu and industry outlook commentary.
Or here, to view a sample General Research Menu and economy & markets commentary.
Click here for a sampling of News Headlines generated by events in a typical game.
If no signal appears at the 44
W$R FORUM! Wall Street Raider now also has a "blog" fan site (not sponsored
by us) -- see the link here....
Check it out, if you want to brag to or otherwise communicate with other Wall
Street Raider addicts...!
To download a free copy of the shareware (evaluation)
version of Wall Street Raider go to our Downloads page
to download from any of many shareware sites that host the program.
Ronin Software is a Software Industry Professionals Member.
|
Motorola Gm3688 Service Manual Exclusive [hot]
Always replace the thermal paste or thermal pads beneath the RF power amplifier module (U101) when reattaching the PCB to the chassis. Failure to do so will cause immediate thermal runaway and destroy the transmitter module.
Inject a calibrated -110 dBm signal at the operating frequency. If no signal appears at the 44.85 MHz first IF test point, replace the first mixer FET or check the LO injection level. Fault 3: Low or No Transmit Power
If the radio was connected to a reversed power source, this diode shorts out to protect the internal circuitry. Use a multimeter to check if it is shorted to ground, and replace it if necessary. Symptom: Poor Receiver Sensitivity
Used primarily for programming, tuning, and standard voice accessories. 8V DC (Max 100mA) Pin 2: BLINK (LED Control) Pin 3: Hook Switch (Monitor) Pin 4: Ground Pin 5: Mic Audio Input Pin 6: PTT (Push-To-Talk) Pin 7: SCI / BUS+ (Programming Data Line) Pin 8: Handset Audio Output 3. Comprehensive Alignment and Tuning Procedure
Experienced bench technicians frequently run into a few common issues with the GM3688. Symptom: No Power
Do not probe your GM3688 with a multimeter blind. You will short the 8-volt rail and kill the controller board. Do not guess which capacitor replaces C262 (I have the manual—it is a 10uF 16V Tantalum).
The 16-pin accessory port supports a wide range of expansion options for custom installations.
Maximizes receiver sensitivity across the entire frequency split.
Over years of service, internal crystal oscillators can drift, causing the radio to stray off-frequency. To correct this, you must perform a radio alignment. Required Equipment A calibrated Service Monitor or RF Signal Generator. A digital multimeter (DMM). An inline wattmeter and dummy load (50 ohms).
Connect the radio's antenna port to the RF communications analyzer via an inline dummy load. Power on the radio and launch the . Select Tuning -> Transmitter -> Reference Oscillator . |
|