Hanmatek Dos1102 Manual Instant

Your oscilloscope menu setting does not match your physical probe switch. Ensure both are set uniformly to 1X or 10X.

Verify that the power cord is firmly seated in the back wall socket and the front power button clicked inward. Check if the power outlet is active.

Set your probe switch to the position (recommended for most measurements). Connect the BNC end of the probe to CH1 .

Your trigger level is not set correctly. Turn the Trigger Level knob until the horizontal trigger line intersects the middle of your displayed waveform. hanmatek dos1102 manual

Controls position, scaling, and coupling for each channel.

Always plug the oscilloscope into a properly grounded electrical outlet. The ground prongs on your BNC inputs are tied directly to the power line ground.

: It provides a "decent" overview of core functions, including safety requirements, quick start procedures, front/rear panel descriptions, and basic control area functions. Safety Guidance Your oscilloscope menu setting does not match your

The manual is also widely available on third-party documentation sites like manuals.plus and manualslib.com . These archives often have the manual in multiple languages, which can be useful if you are not a native English speaker.

Press the menu button and ensure the probe attenuation setting in the digital menu matches the physical switch ( 10X ).

1 GSa/s (Single Channel), 500 MSa/s per channel (Dual Channel) 10K sampling points Vertical Sensitivity 5 mV/div to 5 V/div Time Base Range 2 ns/div to 1000 s/div Max Input Voltage 400V (DC + AC Peak) Display 7-inch TFT LCD, 800 x 480 pixels 🚀 Initial Setup and Probe Compensation Check if the power outlet is active

The DOS1102 features a USB port on the front. You can save screenshots (BMP) or waveform data (CSV) directly to a flash drive for reports or further analysis on a PC. Math Functions:

The 7-inch screen displays your waveforms alongside a wealth of metadata. The top status bar shows the current trigger status (Auto, Ready, Scan, or Stop), the timebase setting, and the horizontal trigger position. The bottom bar displays the vertical scale values for Channel 1 (yellow) and Channel 2 (cyan). The Vertical Control Zone

Install the software driver packages on your computer before connecting the device.