Trane Baysens019c Manual Online

Set the time you want the building to reach its occupied temperature (e.g., 6:00 AM). Use the arrows to set the cooling and heating setpoints.

is a non-programmable, wall-mounted sensor. Its primary job is to provide a 10k ohm resistance signal back to the unit Sensor Type: 10 kΩ, Type II thermistor. Temperature Range: 32°F to 122°F (0°C to 50°C). Fits a standard 2" x 4" vertical junction box. UV-protected Polycarbonate/ABS blend. Wiring and Installation BAYSENS019C

: Built for ReliaTel-controlled units ranging from 3 to 10 tons. trane baysens019c manual

The CR2032 lithium battery preserves clock and calendar settings during power outages. To replace:

Installing this sensor requires a qualified technician due to high-voltage hazards. Trane Commercial HVAC Help Center Mounting Location : Choose an interior wall approximately Set the time you want the building to

Enables fan to run continuously or cycle with heating/cooling.

: Supports 7-day, 5+2 day, or 5+1+1 day options with up to three occupied/unoccupied event pairs per day. System Modes Its primary job is to provide a 10k

Before programming schedules, you must configure the internal clock and system options. Setting Time and Day

typically connects to the unit's control board using a two-wire, non-polarized connection. Placement:

Trane BAYSENS019C is a programmable zone sensor designed primarily for commercial HVAC systems, such as Precedent™ Voyager™ Odyssey™