Ivoclar - Programat P90 Manual Fixed _top_

The Ivoclar Programat P90 Manual Fixed dental sintering furnace is a reliable and efficient solution for dental laboratories seeking to produce high-quality zirconia and other dental restorations. Its ease of use, combined with precise temperature control and safety features, makes it a valuable asset. While it may offer less flexibility than more advanced models with fully programmable features, its performance and the support from Ivoclar Vivadent make it a solid choice for labs of various sizes.

Use only a dry or slightly moist cloth. Never use solvents or compressed air, as the insulation contains ceramic fibers that can release hazardous dust.

The Ivoclar Programat P90 Go to product viewer dialog for this item.

Inspect the black rubber O-ring on the lower firing table plate. Clean it with a lint-free cloth dampened with isopropyl alcohol. If it is cracked or flattened, replace it.

Ivoclar Programat P90 manual fixed, Programat P90 error recovery, Ivoclar furnace manual mode, P90 firmware reset, dental ceramic firing troubleshooting. ivoclar programat p90 manual fixed

If programs fail or the temperature is inaccurate, calibration is required.

: Lacks modern features like Ivoclar’s Crack Detection System (CDS) or thermographic infrared pre-drying.

Warning: Before proceeding, ensure the furnace is turned off, unplugged for 10 minutes (to discharge capacitors), and the chamber is cool (< 50°C).

Wipe down the vertical metal guide rails using a dry microfiber cloth to remove accumulated ceramic dust. The Ivoclar Programat P90 Manual Fixed dental sintering

: Indicates the temperature is too high relative to the target. Professional Repair : Services like Repair.Dental

: Program the exact points where the vacuum pump switches on and off relative to the rising temperature curve. Critical Maintenance: Temperature Calibration

Place the silver wire configuration into the designated calibration holder. The wire must span across the gap without touching the sides of the base.

: Set the furnace on a flat, fire-proof table, ensuring air vents at the rear remain unobstructed. Use only a dry or slightly moist cloth

Detailed mapping of the K-Furnace head, control unit, vacuum pump socket, and keyboard.

Selects the target program slot (supports up to 90 individual programs ).

Check the vacuum hose connection at the back of the furnace. Ensure the hose clamps are secure and the tubing has no micro-fractures.