Wittmann Tempro Plus D 360 Manual Portable
Navigate to the main screen to set your desired process temperature.
The Tempro Plus D 360 is not just a simple controller; it is a powerful diagnostic and process optimization tool.
To ensure safe operation and patient care, follow these safety precautions: Wittmann Tempro Plus D 360 Manual
A mold symbol on the screen changes color based on temperature status: Green (within tolerance), Red (too hot), and Blue (too cold).
The is a state-of-the-art, fully digital water temperature control unit designed for precise thermal management of molds, rollers, and other processing equipment. As part of the renowned Tempro Plus series, the D 360 model bridges the gap between compact single-zone units and large central systems, delivering a heating capacity of up to 9 kW and cooling via an integrated direct water injection system. Navigate to the main screen to set your
Disclaimer: This article is a summary of typical operating procedures. Always refer to the specific, official Wittmann documentation supplied with your unit, as settings and features may vary.
160°C (320°F) pressurized water operation. The is a state-of-the-art, fully digital water temperature
The Tempro Plus D series prioritizes safety, essential for pressurized operation:
| Problem | Possible Cause | Solution | |----------------------|--------------------------------|-----------------------------------------------| | | PID settings incorrect | Run auto-tuning or reset to default PID values. | | Unit not heating | Heater relay failure | Check relay for welding; replace if necessary. | | Low pressure alarm | Water supply interruption | Ensure water supply is open and pressure is adequate. | | Error code E-01 | Sensor break or short circuit | Check temperature sensor and wiring; replace sensor. | | Unit shuts down randomly | Overheating due to poor cooling | Clean the cooling water filter and heat exchanger. | | Pump not running | Motor overload tripped | Reset the overload relay; check for blockage. |
This guide serves as a comprehensive reference overviewing the setup, operation, and troubleshooting protocols typically found in the technical manual. 1. Technical Specifications & Capabilities
Always download the latest manual revision from the Wittmann partner portal. Component suppliers (pumps, sensors) change, and the wiring diagram revision letter (e.g., Rev. G vs. Rev. F) matters when ordering spare parts.